Advertisement
Crimping Instructions
MiniKrimp™ Crimping Machine
1. Place the hose next to
2. Select proper die set.
the fitting and align it
with the knurl marks
on the fitting shell. Mark
the length on the hose.
Push hose into the
fitting until the mark on
the hose is even with
the end of the fitting
shell (lubricate hose*,
if necessary).
5. Slide pusher into place
6. Position the hose and
onto shoulder bolt.
fitting in dies from below.
9. Release pressure, remove
10. Measure crimp diameter of each fitting at the top, middle and bottom of the shell.
finished assembly. Check
Take measurements at a minimum of three places around the shell circumference.
crimp diameter.
Verify crimp diameter is within tolerances.
3a. Using a molybdenum
4. Place proper die ring on
disulfide type grease,
top of the selected die.
apply a thin layer of
grease to the die bowl.
3b. Place unitized die set
into die bowl.
PARKALIGN
®
FEATURE
7. Rest bottom of fitting
8. While holding hose and
fitting into position on
on die step using
die step, begin pumping
PARKALIGN® feature.
hand pump until die ring
contacts base plate.
Note: 1) Hose assemblies must be inspected for cleanli-
ness and should be free of all foreign particles.
2) Parker Hannifin will not accept responsibility for
the operation of, or provide warranty coverage
for, a crimper that is operated by a power unit
other than equipment supplied by Parker
Hannifin for the express purpose of operating
that crimper.
*Do not use water-based or synthetic lubricants
8
Assembling the MiniKrimp
Air Over Hydraulic Pump Upgrade Kit, Part #025411
body of the crimper. Do not
remove the adapter (6-6 CTX-S)
from the cylinder. This adapter
will be used, with an orientation
change, with the Air Over
Hydraulic Pump.
2. Screw (or reorient) the
6-6 CTX-S adapter into the
cylinder port and tighten until
the fitting is facing in the up-
ward direction. Do not loosen
the adapter to reach the correct
orientation as this may cause
leakage.
1. (IF APPLICABLE) Relieve
3. Screw the 6-2 CTX-S adapter
pressure from attached pump.
into the pump and tighten until
Remove the hand pump and
the fitting is facing the direction
bent tube assembly from the
of the fill cap.
™
4. Mount the pump to the right
side of the crimper as shown in
the image to the left using two
1/4" bolt holes on the top of the
crimper. Note that only the top
two bolt holes are used.
5. Attach the 025399 bent tube
assembly to the two adapters.
The longer of the two ends of
the tube will attach to the
pump. Tighten the nuts of the
bent tube to a minimum of
21 ft.-lbs.
Now that steps 1-5 are complete the
MiniKrimp™ is ready for operation.
Reference the Enerpac pump manual
for operating instructions.
9
Advertisement
