Advertisement
Accessories
MiniKrimp™ Crimping Machine
Part # 015307
Upright Vise Mount
• Machined and bent from
1/4" thick 1018 steel
• Mount connects to the bottom
of the MiniKrimp
™
using four
3/8-16 bolts (not included)
Part # 015309
™
• Once connected, MiniKrimp
High Pressure Hose Assembly
can be clamped into a vise for
• Parker 10,000 psi, 1/4 inch ID
operation
hose with 3/8 inch female JIC
connections on both ends
• Hose is 6 feet long
• Hose is used when a flexible
connection is required
between the MiniKrimp
a hydraulic pressure source
Part # 015306
Table Mount
• Machined and bent from 1/4"
thick 1018 steel
• Mount connects to the bottom
Part # 015308
™
of the MiniKrimp
using four
Replacement Connector
3/8-16 bolts (not included)
• Replacement stainless steel bent
™
• MiniKrimp
can then be
tube rigid connector
mounted to a table using the
• For use with 94C-001-PFD
four 3/8" clearance holes on
™
(MiniKrimp
Hand Pump Model)
the other side of the plate
(bolts not included)
™
and
Part # 025349
Replacement Connector
• Replacement stainless steel bent
tube rigid connector
• For use with 94C-002-PFD
™
(MiniKrimp
Air Over
Hydraulic Model)
4
Part # 045234
High Pressure
Hose Assembly
• Parker 10,000 psi, 1/4 inch ID
hose with quick coupler
• Hose is designed to be used
when mounting a hand pump
to the 94C-MKS MiniKrimp
stand's base (see picture
at right)
Part # 94C-MKS
Folding Stand
• Lightweight folding stand
designed exclusively for the
™
MiniKrimp
portable crimper
(works for all versions)
• When not in use, the stand folds
up closely to the MiniKrimp
for storage
• Mounting hardware and safety
instructions are included
• See pictures below for
configuration examples.
• Patent Pending
Hand Pump MiniKrimp
MiniKrimp
with Hand Pump
™
Mounted to Folding Stand
Folding Stand
™
™
Air Over Hydraulic MiniKrimp
™
Air Over Hydraulic MiniKrimp
and Folding Stand
Note: The hydraulic connectors shown
on page 4 are designed exclusively for
use with the Minikrimp
connectors are approved for use with
the MiniKrimp
written consent from Parker Parflex
Division's technical support. Any
worn connectors should be replaced
immediately.
5
and
™
™
™
. No other
™
without expressed
Advertisement
