Page 1
www.garagedoorsonline.co.uk 01926 463888 www.garagedoorsonline.co.uk 5048551A-GB 26/04/07 14:36 Page 1 CONTENTS GENERAL PRESENTATION SAFETY INSTRUCTIONS Caution Safety instructions PRODUCT DESCRIPTION Product components Types of door POINTS TO CHECK PRIOR TO INSTALLATION Preliminary checks Safety instructions INSTALLATION Installation height Detailed description of installation steps PROGRAMMING Programming button description Learning...
Page 2
Failure to comply with these instructions absolves Somfy from any liability resulting from damage that may be caused. Dexxo Pro is a product that must be installed inside the garage with an integrated back-up control system.
(spring tension). Remember that any work performed on door springs may be dangerous. The structure of your garage (walls, lintel, inside surfaces, cross members, door rails…) are used to mount the Dexxo Pro system. Reinforce them where necessary.
Page 4
Checking the chain or belt tension (Fig. 15) Dexxo Pro is supplied with the tension preset and checked. If necessary, adjust the tension. The rubber or tension spring must never be full compressed during operation. Connecting the mains power supply (Fig. 16) [1].
Up to 32 control channels can be stored. Running this procedure for a previously stored channel will clear it. At this stage in the installation process, the Dexxo Pro motor drive unit is ready to run. OPERATING TEST Fig. 20 Using the remote controls Figs.
www.garagedoorsonline.co.uk 01926 463888 www.garagedoorsonline.co.uk 5048551A-GB 26/04/07 14:36 Page 6 Built in lighting operation The light will come on every time the motor drive unit is operated. It will go out automatically after one minute once the door stops. This time delay is adjustable (refer to the Setup chapter).
www.garagedoorsonline.co.uk 01926 463888 www.garagedoorsonline.co.uk 5048551A-GB 26/04/07 14:36 Page 7 SETUP Setup general diagram Fig. 33 Meaning of the different settings Code Description Values Comments Operating mode 0: sequential Automatic closure mode operation is only possible if photoelectric cells are 1: automatic closure fitted, i.e.
Page 8
www.garagedoorsonline.co.uk 01926 463888 www.garagedoorsonline.co.uk 5048551A-GB 26/04/07 14:36 Page 8 Programming example: setting the ”P7” closure approach speed (Fig. 34). Setting up a long soft stop function zone “P7” = 2. Special case: adjusting the position of the door for partial opening (Fig. 35). Select setting “P6”...
Perform a learning cycle. If the fault persists, contact Somfy Technical Support. Accessing stored data To access stored data, select the “Ud” setting then press “OK” as shown in (Fig. 33).
Page 10
Rail: 5.6 to 10 kg depending on the type of rail Opening speed 18 cm/s max. Number of channels that can be stored Somfy radio frequency 433.42 MHz RTS Built in lighting 230 V / 40 W max. E14 socket Remotely controlled lighting 230 V / 500 W max.
- all Somfy products are designed to fulfill your needs in terms of safety, comfort and security. At Somfy, the quest for quality is a continual process. Somfy has built its reputation on the quality of its products and is synonymous with innovation and technological leadership worldwide.
Failure to comply with these instructions absolves Somfy from any liability for any damage that may be caused. Dexxo Pro is a product that must be installed inside the garage with a built-in back-up control system.
Manual release cord operation (Figs. 8 and 9) Dexxo Pro is fitted with a manual release mechanism so that you can move the door manually should a power failure occur, for example. The manual release mechanism should be easily accessible and located no more than 1.80 metres above floor level.
14:37 Page 5 Special operation Depending on the peripherals installed and the operating options set by your installer, the Dexxo PRO system may perform the following special operations: Using Telis or similar remote controls (Fig. 9). Safety photoelectric cell operation.
Indicates that the main power supply to the motor is cut and that the motoris powered by the battery Waiting for a command back-up pack. If other codes are displayed, contact your Somfy installer. PERIPHERALS A number of peripherals are available.
To ensure optimum battery life, we recommend that the power to the motor is switched off and the door is operated for a number of cycles using battery power (three times a year). TECHNICAL SPECIFICATIONS Basic technical specifications Dexxo Pro 800 Dexxo Pro 1000 Mains supply 230 V 50 Hz Power consumed when on standby Max.
Need help?
Do you have a question about the Dexxo Pro and is the answer not in the manual?
Questions and answers