Setting Up Your Rangetop - Dacor Renaissance EG366 Use And Care Manual

Burner and Grate Assembly
WARNING
Assemble the burners and grates only when the rangetop
is cool.
Crown Burners
1. Put the burner heads in place as shown below.
The locating tab on the burner head goes in the
keyed hole as shown.
2. Put the burner rings on the burner heads as
shown below. Match the tabs on the bottom of
the ring to the slots on the burner head. Twist
each ring back and forth slightly to make sure it
is properly seated.
3. Put the burner caps on top of the burner rings.
The ridge around the bottom edge of the cap
goes around the top of the burner ring.
Step 3
Ridge on bottom
of burner cap
Step 2
Tabs
Slots
Step 1
Put locating tab
into keyed hole
Keyed hole
Crown Burner Assembly

Setting Up Your Rangetop

Burner ring
Burner head
Burner base
Stack Burners
1. Put the burner rings on the burner bases as
shown below. Match the correct sizes. The
bottom of the correct size burner ring fits inside
the top of the matching burner base.
2. Turn the ring until it drops into place. Twist each
ring back and forth slightly to make sure it is
properly seated.
3. Put the burner caps on top of the burner rings.
The ridge around the bottom edge of the cap
goes around the top of the burner ring.
Step 2
Step 1
Stack Burner Assembly
Installing the Grates
Gently set the grates on top of the spill tray. Put the
legs of each grate into the corresponding dimples.
On model EG366, the middle grate is larger than the
other two.
5
Ridge on bottom
of burner cap
Step 3
Burner ring
Burner base
continued...