Page 1
“An ounce of prevention...,” and all that. The SEQ 30S is a stereo equalizer, so adjusting any slider affects both channels simultaneously. Begin by setting all sliders to their center detent (0 dB), and the INPUT LEVEL to its center detent (0 dB).
Page 2
INPUT LEVEL control and indicators This controls the overall level. 0 dB gain is reached at the center detent with all sliders centered at their 0 dB detents. Set the INPUT LEVEL to give equal volumes Filter level slide controls with the EQ switched to ACTIVE or BYPASS, after setting the sliders (see EQ Each of these sliders control the BYPASS switch below).
Page 3
POWER switch and LED Your basic, straightforward power switch. When the yellow LED is lit, the SEQ 30S is ready to go. LEFT & RIGHT INPUTS Choose between the balanced XLR Cable Wiring or the balanced/unbalanced ¼" TRS In agreement with IEC and AES/ jacks, but only use one.
Page 5
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by Rane Corporation could void the user's authority to operate the equipment. This Class B digital apparatus complies with Canadian ICES-003.