Rear Panel Layout; External Speaker Out; Mains Input - Vox AC4HW1 Owner's Manual

REAR PANEL LAYOUT

1
1. FOOT SWITCH Jack
2.

EXTERNAL SPEAKER OUT

NOTE: When an external cabinet is connected, the internal speaker is dis-
WARNING: To ensure that your system works correctly, you must observe the
a) Don't use an external cabinet whose impedance is other than 16
b) Don't connect a speaker whose rated input capacity is less than 4
c) You must use a speaker cable to connect an external speaker. Don't
d) You must turn off the power before connecting the cable. Connecting
3.

MAINS INPUT

NOTE: Use only the power cable that is included with the AC4HW1. Using
2
This is where you connect the included Foot Switch (VFS1) to switch
between HOT and COOL modes on the TOP BOOST Channel (HOT
mode must be engaged on the control panel for the Foot Switch to
operate).
This is used to connect the AC4HW1 to any 16ohm cabinet.
connected.
following points.
ohms.
Watts. The speaker may be destroyed if you ignore this caution—not
recommended!
use a shielded cable like the one you use to connect a guitar to an
amp.
the cable while the power is turned on may damage your amp.
Connect your supplied mains power lead here
another power cable may cause malfunctions.
The specific mains input voltage rating that your amplifier needs to run
at is located on the rear panel of your amplifier. Before making any
connections or powering up the amplifier, make sure the correct volt-
age is set. If you have any doubt, refer to your local VOX dealer.
3
5