Nikon COOLPIX 3700 Repair Manual page 5

DISASSEMBLY
Points to notice for Lead-free solder products
・Lead-free solder is used for this product.
・For soldering work, the special solder and soldering iron are required.
・Do NOT mix up lead-free solder with traditional solder.
・Use the special soldering iron respectively for lead-free solder and lead solder. They cannot be used in
common.
Note: ① Be sure to remove the SD memory card and batteries before disassembly.
② When disassembling, make sure to memorize the processing state of wires, screws to be fixed
③ Because electrical parts are easily damaged by static electricity, make sure that you are well
Front cover, Rear cover
・ Take out 2 screws ( ① : M1.4×3).
・ Take out 3 screws ( ② : M1.7×4).
・ Take out 2 screws ( ③ : M1.7×2.5).
・ Take out 1 screws ( ④ : M1.7×3.5).
・ While pushing in the direciton of (↓), open the rear cover ( ⑤ ) to remove the connector ( ⑥ ).
・ Remove the front cover ( ⑦ ).
①
②
WARNING
！
Due to an internal high voltage area, take extra care not to get an
内部に高電圧部あり。カバーを外す時は感電に注意すること。
electric shock when detaching the covers.
After removing the covers, be sure to discharge the main condenser
カバーを外した後は、修理指針の指示に従ってメインコンデン
according to the instructions of the repair manuals.
サーの放電を必ず行うこと。
and their types, etc.
earthed/grounded.
- D1 ･ E3700 -
警告
①
⑥
③
④
⑦
VAA18001-R.3622.A
⑤
②
③