Important Safety Instructions - Motorola NTN7209A Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
1. This document contains important safety and operating instructions for the
NTN7209 (model AA16740) charger.
2. Before using the battery charger, read all the instructions and cautionary markings
on (1) battery charger, (2) battery, and (3) radio using battery.
3.
To reduce risk of injury, charge only Motorola nickel-cadmium, or
nickel-metal hydride rechargeable batteries listed for charger NTN7209
(model AA16740). Other types of batteries may burst, causing personal
injury and damage.
4. Do not expose the charger to rain or snow.
5. Use of an attachment not recommended or sold by Motorola may result in a risk of
fire, electric shock, or injury to persons.
6. To reduce risk of damage to the electric plug and cord, pull by the plug rather than
the cord when disconnecting the charger.
7. Make sure the cord is located so that it will not be stepped on, tripped over, or
subjected to damage or stress.
8. An extension cord should not be used unless absolutely necessary. Use of an
improper extension cord could result in a risk of fire and electric shock. If an
extension cord must be used, make sure:
a. that the pins on the plug of the extension cord are the same number, size,
and shape as those on the plug of the charger;
b. that the extension cord is properly wired and in good electrical condition; and,
c. that the cord size is 18AWG for lengths up to 100 feet and 16AWG for lengths
up to 150 feet.
9. Do not operate the charger with damaged cord or plug - replace them immediately.
10. Do not operate the charger if it has received a sharp blow, has been dropped, or
damaged in any way; take it to a qualified service technician.
11. Do not disassemble the charger; take it to a qualified service technician when
service or repair is required. Incorrect reassembly may result in a risk of electric
shock or fire.
12. The fuse should only be replaced by type 5MF 1.6A, 250V, manufacturer BEL.
13. Maximum ambient temperature around the power supply must not exceed 40°C
(104°F).
CAUTION
English
1