Attaching / Removing The Floor Nozzle; Attaching The Accessory Tool - Simplicity a-go-go Owner's Manual

ASSEMBLING THE VACUUM
Attaching the Floor Nozzle
Place the floor nozzle on the floor with the neck
locked in the upright position. Line up the neck
of the floor nozzle with the inlet at the base of the
vacuum. (Fig. 1) Push until it clicks into place.
Removing the Floor Nozzle
Press the floor nozzle release button at the base
of the vacuum then pull the floor nozzle
off the inlet. (Fig. 2)

Attaching the Accessory Tool

Insert the base of the combination crevice/dusting
tool into the tool holder on the side of the vacuum.
(Fig. 3)
6
Fig. 1
Fig. 2
Fig. 3