Maintenance - WAGNER W 570 FLEXIO Manual

GB
Assembly
The unit may only be operated with an integer diaphragm (Fig. 13, 3).
1) Place the diaphragm (Fig. 13 ,3) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 13 ,2) and screw it closed.
3) Place the ventilating hose (Fig. 13, 1) on the valve cover and on the nipple at the gun
body.
Attention! Never operate the device if the nozzle seal is either damaged or
missing. If the nozzle seal is either missing or damaged liquids can enter
the device and increase the risk of an electric shock.
4) Push the nozzle seal (fig. 20, 1) over the needle (3); the groove (slot) should point
towards you.
5) Put the nozzle (fig. 20, 2) onto the gun body and find the correct position by turning it.
6) Put the air cap onto the nozzle and tighten it using the union nut.
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.

20. Maintenance

WARNING! Never operate the machine without the air filter;
dirt could be sucked in and interfere with the function of the
machine. Check the air filter after each use for contaminants.
Disconnect plug before changing parts.
1) Open the air filter lid with the help of the stirring rod. (Fig. 21)
2) Pull out the air filter and replace it if necessary, depending on how soiled it is.
3) First, push the new air filter into the bottom part of the compartment. (Fig. 22)
4) Next push it completely into the compartment.
In order to push the air filter into the compartment completely, we recommend using
the stirring rod.
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part. (Fig. 23, 6 and fig. 24,5)
32
W 570 Flexio