Exchanging The Elbow Connector - Miele CVA 6805 Operating And Installation Instructions

Exchanging the elbow connec-
tor
If you can prepare only hot milk instead
of milk froth, check the following first:
– Is the milk in the milk flask cold
(< 50°F / 10°C)?
– Have the main dispenser and milk
flask lid been cleaned carefully?
– Is the main dispenser correctly
mounted?
If you still cannot prepare milk froth, fol-
low the steps described to exchange
the elbow connector.
You need the elbow connector that was
provided as a spare part.
Do not use a needle or similar imple-
ment. This would damage the com-
ponents.
 Open the service cover on the back
of the appliance door.
Frequently Asked Questions
 First release air intake tube  from
the opening  Then pull off the el-
bow connector .
 Pull both tubes out of the elbow con-
nector.
 Use the cleaning brush supplied to
clean air intake tube  under running
water. "Blowing through" can help to
dislodge blockages.
 Insert the brush in milk tube . Move
the brush back and forth as far as
possible until all milk deposits have
been removed.
 Now take the new elbow connector
(you can throw away the old elbow
connector in the household trash).
89