Exchanging The Elbow Connector - Miele CVA 6800 Operating And Installation Instructions

Frequently Asked Questions
Exchanging the elbow connec‐
tor
If you can prepare only hot milk instead
of milk froth, check the following first:
– Is the milk in the milk flask cold
(< 50°F / 10°C)?
– Have the main dispenser and milk
flask lid been cleaned carefully?
– Is the main dispenser correctly
mounted?
If you still cannot prepare milk froth, fol‐
low the steps described to exchange
the elbow connector.
You need the elbow connector that was
provided as a spare part.
Do not use a needle or similar imple‐
ment. This would damage the com‐
ponents.
Open the service cover on the back
of the appliance door.
88
First release air intake tube
the opening Then pull off the el‐
bow connector
Pull both tubes out of the elbow con‐
nector.
Use the cleaning brush supplied to
clean air intake tube
water. "Blowing through" can help to
dislodge blockages.
Insert the brush in milk tube
the brush back and forth as far as
possible until all milk deposits have
been removed.
Now take the new elbow connector
(you can throw away the old elbow
connector in the household trash).
from
.
under running
. Move