Advertisement
Available languages
Available languages
SPECIFICATIONS
Voltage (by areas)*
Power input
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
•Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case (Molded plastic) ............................................. 1
(2) Side Handle .............................................................. 1
(3) Stopper ...................................................................... 1
(4) Hexagon Bar Wrench (for 6 mm screw) ........... 1
(5) Hexagon Bar Wrench (for 5 mm screw) ........... 1
(6) Hammer Grease A .................................................. 1
(7) Dust Cup .................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Through-hole drilling (Rotation + Striking)
(1) Drill bit (hexagon shank)
Overall length: 280, 400, 505 mm
External dia.: 16, 19, 22, 25, 28, 32, 38 mm
Anchor hole drilling (Rotation + Striking)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12, 14.3,
14.5, 17.5,
21.5 mm
Taper shank
Application drill bit
adapter
Morse taper
Drill bit (taper shank)
(No. 1)
11, 12, 14.3, 14.5, 17.5 mm
Morse taper
Drill bit (tape shank)
(No. 2)
21.5 mm
Taper shank adapter formed A-
A-taper
taper or B-taper is provided as
optional accessory, but drill bit for
B-taper
it is not provided.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
(2) Taper shank
adapter
950 W*
Drill bit: 40 mm
Core bit: 105 mm
360/min.
2800/min.
6.6 kg
Large dia. hole boring (Rotation + Striking)
(1) Center
(Guide
pin
plate)
(1) Center pin
Applied to core bits from 38 mm to 105 mm
Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm
or 29 mm)
(3) Core bit shank
Applied to core bits above 38 mm
Applied to core bits below 35 mm
Anchor work (for self-drilling anchors)
(1) Anchor adapter (for Rotation + Striking)
Anchor sizes:
W1/4, W5/16, W3/8, W1/2, W5/8
(No. 20) (No. 25) (No. 30) (No. 40) (No. 50)
(2) Drift key
Crushing (Striking)
(1) Bull point
Overall length: 280, 450 mm
Groove digging and edging (striking)
(1) Cold chisel
Overall length: 280, 450 mm
English
(2) Core
(3) Core bit
bit
shank
6
Advertisement
