Adjusting The Exhaust Gas Volume - Yamaha FJR1300A Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
9. Measure:
• Engine idling speed
Out of specification → Adjust.
Make sure that the vacuum pressure is within
specification.
10.Stop the engine and remove the measuring
equipment.
11.Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" on page 3-8.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
12.Install:
• Caps
13.Install:
• T-bar
• Rider seat
Refer to "GENERAL CHASSIS" on page 4-1.
EAS20600

ADJUSTING THE EXHAUST GAS VOLUME

NOTE:
Be sure to set the CO density level to standard,
and then adjust the exhaust gas volume.
1. Turn the main switch to "OFF".
2. Simultaneously press and hold the "SE-
LECT" and "RESET" buttons, turn the main
switch to "ON", and continue to press the but-
tons for 8 seconds or more.
"SELECT"
"RESET"
NOTE:
• All displays on the meter disappear except the
odometer/tripmeter/fuel reserve tripmeter dis-
plays.
• "dIAG" appears on the odometer/tripmeter/fuel
reserve tripmeter LCD.
email: info@motomatrix.co.uk
3. Press the "SELECT" button to select the CO
adjustment mode "Co" "1" or the diagnostic
mode "dIAG".
4. After selecting "CO", simultaneously press
the "SELECT" and "RESET" buttons for 2
seconds or more to activate the selection.
5. Press the "SELECT" and "RESET" buttons to
select a cylinder number "1".
NOTE:
The selected cylinder number appears on the
clock LCD.
• To decrease the selected cylinder number,
press the "RESET" button.
• To increase the selected cylinder number,
press the "SELECT" button.
6. After selecting the cylinder number, simulta-
neously press the "SELECT" and "RESET"
buttons for 2 seconds or more to activate the
selection.
7. Change the CO adjustment volume "2" by
pressing the "SELECT" and "RESET" but-
tons.
3-7
ENGINE
1
1
2