Installing The Drive Shaft And Final Drive Assembly - Yamaha FJR1300A Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
EAS23660
INSTALLING THE DRIVE SHAFT AND FINAL
DRIVE ASSEMBLY
1. Lubricate:
• Drive shaft spline (final drive pinion gear side)
Recommended lubricant
Molybdenum disulfide grease
2. Lubricate:
• Drive shaft spline (universal joint side)
Recommended lubricant
Lithium-soap-based grease
3. Install:
• Oil seal "1"
• Washer "2"
(with the fork seal driver weight "3" and fork
seal driver attachment "4")
Fork seal driver weight
90890-01184
Fork seal driver attachment
90890-01186
Replacement 27 mm
YM-A9409-1
4. Install:
• Drive shaft
(to the final drive pinion gear)
5. Install:
• Universal joint
• Final drive assembly
NOTE:
Align the drive shaft splines with the driven yoke
of the universal joint.
6. Tighten:
• Final drive assembly nuts
Final gear case nut
42 Nm (4.2 m·kg, 30 ft·lb)
7. Install:
• Sidestand
email: info@motomatrix.co.uk
3
4
2
1
4-100
• Left footrest assembly
Left footrest assembly/sidestand
bolt
65 Nm (6.5 m·kg, 47 ft·lb)
Left footrest assembly bolt (M8)
28 Nm (2.8 m·kg, 20 ft·lb)
Left footrest assembly bolt (M10)
49 Nm (4.9 m·kg, 35 ft·lb)
NOTE:
Install the left footrest assembly/sidestand bolts
"1", left footrest assembly bolts (M8) "2" and left
footrest assembly bolt (M10) "3" temporarily and
then tighten them to the specified torques in the
proper tightening sequence as shown.
2
3
8. Install:
• Shift arm "1"
NOTE:
Align the punch mark "a" in the shift shaft with
the slot in the shift arm.
9. Install:
• Rear wheel
Refer to "REAR WHEEL" on page 4-20.
10.Fill:
• Final gear case
Refer to "CHECKING THE FINAL GEAR OIL
LEVEL" on page 3-25.
11.Check:
• Shift pedal position
Refer to "ADJUSTING THE SHIFT PEDAL"
on page 3-25.
SHAFT DRIVE
1