KTM 690 Duke EU 2012 Owner's Manual page 88

WHEELS, TIRES
–
Engage the counter bearing of the brake caliper support
the rear wheel into the swingarm and engage the brake disc. Lay the chain on the rear
sprocket and mount the wheel spindle.
–
Mount chain adjuster
Info
Mount the left and right chain adjusters in the same position.
–
Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten the nut.
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
–
Insert wheel speed sensor
Guideline
Remaining screws, chassis
B00957-11
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
Subsequent work
–
Take the motorcycle off of the rear wheel stand. (
–
Check the chain tension. (
and nut .
2 3
M25x1.5
into the hole. Mount and tighten screw
4
M6
p. 62)
and swingarm. Carefully lift
A
.
B
90 Nm
(66.4 lbf ft)
.
5
10 Nm (7.4 lbf ft)
p. 58)
86