Park Brake Assembly - lehman Trikes DYNA Installation Instructions Manual

Park Brake Assembly

Note: Verify all brake lines and hardware are tight before bleeding system.
5. Add brake fluid (refer to OEM reservoir cap for brake fluid requirements) to brake system and work
brakes to fill lines.
6. Remove rubber caps on bleeder valves. Install clear brake bleeder hose over bleeder valve on caliper.
7. Pump brake pedal to build pressure. While holding the brake pedal, open bleeder valve to release
pressure and remove air from system. Repeat bleeding on both calipers until fluid is solid without
bubbles in bleeder hose.
8. Tighten bleeder valves and check for leaks.
9. Install master cylinder reservoir cap with new screws. Do not over tighten cap screws.
Park Brake Assembly
1. See Fig. 1. Install park brake cable to caliper brackets. Secure cable to bracket with cir-clip provided on
cables.
Attach to
caliper
RH Side
13
Fig. 1
Secure to
bracket
2006-2013 FXD Renegade Rev. 6