Dyna Head Bolt Procedure - lehman Trikes DYNA Installation Instructions Manual

12. See Fig. 9. Sway bar bracket is attached to upper rear of differential housing.
13. Tighten 3/8" nuts on stabilizer bar until there is no play in grommets. DO NOT COMPRESS
GROMMETS.
Caution: Make sure sway bar is not pulling or pushing on Lehman frame when trike is at rest as this
could alter power train alignment. Make sure shocks are running vertical after sway bar is
tightened. There are (6) 3/8" flat washers supplied to shim grommets on sway bar if needed.
Dyna Head Bolt Procedure (Bolt Bag LCK5064)
1. Remove existing 3/8" head bolts and washers from engine mount bracket on LH side.
2. Apply Loctite 242 to threads of 3/8" x 1 ½" hex flange locking bolts.
3. Assemble bolt, spacer (LS1189) and external tooth lock washer in appropriate order.
4. Torque bolts to 42 ft.-lbs.
Fig. 9
19
2006-2013 FXD Renegade Rev. 6