lehman Trikes DYNA Installation Instructions Manual page 8

6. 06-07 Models: See Fig. 3. Install swingarm pin brace
(LB6110) to RH side of transmission housing with
original hardware from case. Leave bolts for this bracket
loose until swingarm installation is complete.
7. 08-13 Models: See Fig. 4. Install swingarm pin brace
(LB6110) to RH side of transmission housing with
original hardware from case. Install (S001057- Fig. 4)
spacer between case and pin brace. Leave bolts for this
bracket loose until swingarm installation is complete.
All Models
8. Install Lehman swingarm with word "TOP" (stamped into
swingarm collar) facing upward.
9. See Fig. 4.Place swingarm pivot bolt spacer
(LS6129) on RH side of swingarm between swingarm
bearing and LB6110 bracket.
10. On pivot bolt (LP6105) install a new (CW2032)
washer against bolt head.
11. Holding swingarm in place, insert pivot bolt assembly
through RH side and into swingarm and transmission
case. Start stock flange nut as bolt emerges from
bearing on LH side. Use Loctite 242 on threads.
Torque to 150 ft. lbs.
Note: Make sure bolt end does not contact primary
case.
12. See Fig. 3. Using Loctite 242 tighten all fasteners for LB6110 swingarm pin bracket. Torque to 20 ft.
lbs.
13. Be sure swingarm moves freely up and down with no side to side movement.
Fig. 3 LB6110 Pin Brace, 06-07 Models
LS6129
2006-2013 FXD Renegade Rev. 6
7
Fig. 3
Fig. 4
S001057 Spacer-
2008+ Models
CW2032