lehman Trikes DYNA Installation Instructions Manual page 11

5. Support swingarm with jack stands.
6. See Fig. 5. With differential assembly on lift, slide
belt over LH axle tube and against center housing.
7. See Fig. 5. Set differential assembly on swingarm
adapter plates. Slide differential as far forward as
possible. Set jack stands under axle tubes.
8. Tighten pinch block hardware just enough to allow
differential to slide on swingarm adapter plates.
9. See Fig. 5. Remove upper, lower and rear housing
plates.
10. See Fig. 6. Carefully slide belt over pulley.
11. Reinstall housing plates with original hardware using
Loctite 242. Install all hardware before tightening.
Torque hardware to 17 ft. lbs.
I
nstall belt
10
Fig. 5
Remove plates
Fig. 6
2006-2013 FXD Renegade Rev. 6