Makita DTL061 Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -3. Hammer Section (cont.)
ASSEMBLING
Note 3: Internal gear 69 is reversible when assembled to Housing L
although there is a notch on one of the two protrusions.
Note 4: When assembling DC Motor to Gear section, do not force
the pinion gear of DC Motor into Gear section.
Be sure to insert the pinion gear into three Spur gears (Spur gear 29)
while engaging them. Otherwise, DC Motor will run slower with
occasional siren-like noise. In this case, disassemble the machine
again, and insert the pinion gear correctly as described above.
Note 5: Do not forget to put the following parts in place before assembling
Housing R to Housing L (Fig. 13): Cushion, Pin 1.5, Rubber pin 5
Fig. 13
Cushion
Pin 1.5
P 6/ 8
Rubber pin 5