Makita DTL061 Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Bit Holder Section
DISASSEMBLING
Open the ends of Ring spring 11 using 1R291 while pressing Ring spring 11 with the thumb of the other hand
in order not to allow Flat washer 12 and Compression spring 13 to pop out.
By lifting up Ring spring 11 carefully as described in Fig. 6, the following parts can be removed:
Flat washer 12, Compression spring 13, Sleeve, Steel ball 3.5 (2 pcs)
Fig. 6
1R291
Ring spring 11
Lift up the side opposite to the ends
of Ring spring 11 in the direction
of the arrow with index finger.
[3] -3. Hammer Section
DISASSEMBLING
1) Remove Angle head complete by unscrewing (+) Hex bolt M5x30.
2) Remove Housing R by unscrewing eight 4x18 Tapping screws. (Fig. 7)
3) Remove Switch lever from Housing L, then by levering up DC Motor with slotted screwdriver as illustrated in Fig. 8,
the following parts can be removed from Housing L as an assembly: DC Motor, Gear section, Hammer section
4) The assembly can be disassembled by hand except Hammer section. (Fig. 9)
Fig. 7
Tapping screw 4x18 (8 pcs)
Fig. 9
Flat washer 12
DC Motor
Internal gear 69 Ring 32 Spur gear 29 (3 pcs)
Flat washer 12
Compression
spring 13
Sleeve
Fig. 8
DC Motor Gear section
Hammer section
Steel ball 3.5
(2 pcs)
Hammer section
Switch lever
Flat washer 15
Anvil Rubber washer 21
Sleeve 15
P 4/ 8