Starting Loop Playback From A Cue Point Before The Normal Start Point "A; 3) Exit And Reloop - Denon DN-2700F Operating Instructions Manual

Loop playback
• Once the loop is ready for playback (the LOOP LED is lit solid), press the PLAY/PAUSE button. Loop playback
begins from the start point (A).
• When the end point (B) is reached, playback starts over immediately from the loop start point (seamless loop).
CAUTION: The negative range of the pitch and pitch bend control is limited to -20% during loop playback. However,
the full positive 50% range is still a available.
Stopping loop playback
• Loop playback is repeated until loop mode is exited or canceled using one of the following methods:
• Press the LOOP button to cancel loop mode and continue normal playback when the B point is reached.
• Press the CUE button to stop loop playback and cue to the current cue point.
• Press the EXIT/RELOOP button to exit the loop and continue normal playback when the B point is reached (See (3)
Exit and Reloop below)
Clearing loop points
• Pressing the CLEAR button and then the LOOP button clears all loop information. The LOOP, A, and B LEDs will
turn off.
• Pressing the CLEAR button and then the A button clears the start point "A" only.
• Pressing the CLEAR button and then the B button clears end point "B" only.
CAUTION: The player can not clear the loop points during loop playback operation. Also never press the CLEAR
button and the LOOP, A, or B buttons at the same time.

(2) Starting Loop Playback From a Cue Point Before The Normal Start Point "A"

• After the loop start and end points have been set, the point at which playback starts can be moved to a point before
the loop start point A.
• This function allows you to seamlessly switch from normal playback to loop playback.
CAUTION: To start playback before the loop start point, it is necessary that duration of loop is longer than several
frames. If the duration is not longer than this, the LOOP LED will turn off when you press the CUE button,
i ndicating that loop playback is not possible.
Starting playback from a previously set cue point
• After the preparation for loop playback is completed ( LOOP, A, B LEDs lit solid) press the CUE button. The player
moves to the pre-set cue point. Note that the three loop LEDs stay lit. (If the loop LED turns off, see CAUTION
above)
• Press the PLAY/PAUSE button to start playback. When the loop start point is reached loop playback will start.
Setting a new cue point after the loop is ready
• Set up a loop and prepare the loop for playback as described above.
• When the loop is ready (LOOP, A, B LEDs will be lit solid), press the LOOP button to temporarily disable the loop
(LOOP LED will turn off).
• Turn the shuttle or jog dial counterclockwise to locate the point where playback will start. This point must be
before the A point.
• Press the CUE button to set this as the cue point.
• Press the LOOP button again to prepare the unit for loop playback. The LOOP LED will light solid and the unit will
cue to the A point.
• Press the CUE button. The player will cue to cue point, and the LOOP LED will remain lit (if the loop LED turns off,
see CAUTION above)
• Press the PLAY/PAUSE button to start playback. When the loop start point is reached, loop playback will start.

(3) Exit and Reloop

• The Exit and Reloop functions which are unique
to the DN-2700F allow you to exit the loop,
i nstantly return to the loop at any time.
Exit
• Press the EXIT/RELOOP button during loop play-
back to restore normal playback. When the B
point is reached, the LOOP LED will blink and the
disc will continue playing beyond the B point.
18
Start point
Figure 20
Start point End point
Figure 21
End point