Denon DN-2700F Operating Instructions Manual page 21

Storing start and end track data
2-1. Use the number keys to input a digit for the tens
place of the track number. If the number entered is
valid, the cursor will move to the ones place. When
the digit for the ones place is input, the cursor moves
to the tens place of the MINUTE display.
4-1. Input a two digit number for the end track number using the
same procedure as above. Memory playback will stop at the
end of selected track.
Repeat steps 1 to 5 above to store multiple sets of data. The blinking MEMORY location increases by one each time a
new set of data is stored.
CAUTION: The current digit in the TRACK display flashes if an invalid number is entered.
1.
3. Press the END button. The start track
number is stored in the memory, and the
end track number can now be set. The
"END" indicator on the LCD lights.
5.
Figure 25
Press button
or above the numerical key pad to select
the disc for which the data is to be input. The memory step
number flashes in the MEMORY section of the LCD.
2-2. Press the TRACK button
the start track number. The selected track is
searched and cueing to music starts. When
cueing completed, music start time is dis-
played.
4-2. Press the TRACK button
to select the end track number. The
selected
cueing to music starts. When cueing
completed, music start time is dis-
played. Memory playback will stop
at this time.
The press the STORE button to store the start and end track
data in memory. The cursor disappears and the MEMORY
display stops flashing.
to select
track is searched and
21