Transmitter Installation (Optional) - Samsung MH18VP2X Installation Manual

Transmitter Installation (Optional)

MH18VP2X / MH19VP2X / MH052FXEA2
Accessories (Transmitter)
Transmitter Transmitter power
cable
Accessories (Outdoor Unit)
3-wire
Power Cable
(option)
Rubber Leg
1 Fix the case at 3 hinges on the side of the control box in the outdoor unit.
(See the picture)
2 Attach the transmitter PCB to the case in the control box in the outdoor
unit, then connect the power and the communication cable between the
transmitter and the outdoor unit; refer to the figure of page 15.
3 If you install a transmitter to an outdoor unit, every indoor unit which is
connected to an outdoor unit can be controlled simultaneously.
4 Each outdoor unit connected to the same centralized controller has its
own transmitter.
Transmitter Installation Manual
communication cable
Drain Plug
2-wire
Assembly Cable
(option)
Flare Nuts, 6.35mm Flare Nuts, 9.52mm
outer pipe diameter
outer pipe diameter
I
NSTALLING THE
Case Cable-tie
Transmitter power
cable
Energy Label
7seg. LED
Display side
Fix the case with hinges
(Control Box in the outdoor unit)
O U
UTDOOR NIT
13
E-