Rear System Fan; Dedicated Ilo Management Port - HP ProLiant ML310e Gen Maintenance And Service Manual

Rear system fan

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the tower bezel.
3.
Remove the access panel
4.
Remove the air baffle
5.
Remove any existing expansion board that blocks access to the rear system fan connector.
6.
Disconnect the fan cable.
7.
Press and hold the fan latch, and then remove the fan.
8.
To replace the component, reverse the removal procedure.

Dedicated iLO management port

To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the tower bezel.
3.
Remove the access panel
4.
Remove the air baffle
5.
Remove the rear system fan
6.
("Access panel" on page 31).
("Air baffle" on page 32).
("Access panel" on page 31).
("Air baffle" on page 32).
("Rear system fan" on page 50).
Removal and replacement procedures 50