PROGRAMMING OPTIONS
TURNING THE RINGERS ON OR OFF
The ringer for each of the 4 lines can be turned ON or OFF. The default setting is ON.
1 .
While in the PROGRAM mode, press the
button until the following screen
appears:
RINGER ON/OFF
: select
:
enter
2 .
Press the
button to enter.
L1 RINGER ON/OFF
: select
:
enter
3 .
Use the
buttons to select the desired
ringer, 1-4.
4 .
Press the
button to enter.
L1 RINGER ON/OFF
= On
: select
SAVE?
CHANGE THE RINGER TYPES
There are 4 ringer tones, or types, that can be selected. The default is 1. Changing the ringer
types by line is useful if you want to distinguish which line is ringing audibly without having to
see the LINE indicators on the telephone itself.
1 .
While in the PROGRAM mode, press the
button until the following screen
appears:
RINGER TYPE
: select
:
enter
5 .
Use the
buttons to change the
setting to OFF.
L1 RINGER ON/OFF
= Off
: select
SAVE?
6 .
Press SAVE to accept the setting.
L1 RINGER ON/OFF
= Off
Programmed!
7 .
Repeat for the other lines, or select ALL
RINGER ON/OFF to determine setting for
all 4 lines.
2 .
Press the
button to enter.
L1 RINGER TYPE
: select
:
enter
3 .
Use the
buttons to select the desired
line, 1-4.
12
PROGRAMMING OPTIONS
CHANGE THE RINGER TYPES (cont.)
4 .
Press the
button to enter.
L1 RINGER TYPE
= Type 1
: select
SAVE?
5 .
Use the
buttons to select the ringer
type. As you scroll through the types, a
sample of the actual ringer will be heard.
L1 RINGER TYPE
= Type 2
: select
SAVE?
SETTING THE DELAY RING
The DELAY RING is useful in installations where all 4 lines are common (square) and a
receptionist is answering all calls. Each extension would activate the DELAY RING for the
desired period of time except for the receptionist.
Incoming calls would ring at the receptionist extension ONLY for the DELAY RING time. If the
receptionist doesn't answer, after that time other extensions would begin to ring. By varying the
delay ring time, a hierarchy of back-up for the receptionist can be defined.
Most ring cycles are 6 seconds per ring. So to delay for two rings, program 12 seconds. For
three rings, program 18 seconds, and so on. Programming is in two second increments. The
default is DELAY RING OFF.
NOTE TO VOICE MAIL SUBSCRIBERS:
If you set the DELAY RING for LONGER than the number of rings that the voice mail waits before answering,
the phone will never ring.
1 .
While in the PROGRAM mode, press the
button until the following screen
appears:
DELAY RING
: select
:
enter
6 .
Press SAVE to accept the setting.
L1 RINGER TYPE
= Type 2
Programmed!
7 .
Repeat for the other lines.
2 .
Use the
buttons to change the
desired ring delay.
DELAY RING
= 12 sec
: select
SAVE?
3 .
Press SAVE to accept the setting.
13