Setting Auto-Mute; Auto Intercom Answer - SBC -420 User Manual

PROGRAMMING OPTIONS
PROGRAMMING LINE GROUPS / PRIVATE LINE
The 420 system can support up to 12 extensions and 15 lines. This is possible by using line 4
for line groups. This allows additional lines to be shared by extensions. The 420 must be
programmed for line groups for the system functions to operate properly. The chart below
describes a typical line group application using eight lines.
Department Line 1 Line 2 Line 3 Line 4 Line 5 Line 6 Line 7 Line 8
Reception EXT 11
Sales EXT 12
EXT 13
EXT 14
Credit EXT 15
EXT 16
EXT 17
Warehouse EXT 18
EXT 19
EXT 20
Vice President EXT 21
President EXT 22
Calls can only be transferred between extensions sharing the same line group. Line 7 and 8 are
private and calls cannot be transferred to any other extension.
= Line Connected PRV = Private Line
The chart below describes a system where all extensions have a private 4
L1 L2 L3 L4 L5 L6 L7 L8 L9 L10 L11 L12 L13 L14 L15
EXT 11 PRV
EXT 12 PRV
EXT 13 PRV
EXT 14
EXT 15
EXT 16
EXT 17
EXT 18
EXT 19
EXT 20
EXT 21
EXT 22
PRV
th
line.
PRV
PRV
PRV
PRV
PRV
PRV
PRV
PRV
16
PROGRAMMING LINE GROUPS / PRIVATE LINE (cont.)
1 .
While in the PROGRAM mode, press the
button until the following screen
appears:
LINE GROUP
: select
: enter
2 .
Press the button to enter.
LINE GROUP
= L04
: select
SAVE?
When set to ON, the auto-mute feature automatically mutes the microphone of an extension
receiving a paging call. Setting this feature to OFF allows the paging party to immediately hear
the paged extension. This setting is useful as a ROOM MONITOR and for automatic hands free
PRV
communication. See PAGING A SINGLE EXTENSION on page 28.
1 .
While in the PROGRAM mode, press the
button until the following screen
appears:
AUTO-MUTE
: select
: enter
2 .
Press the button to enter.
AUTO-MUTE
= On
: select
SAVE?

AUTO INTERCOM ANSWER

If auto-mute of one extension is set to OFF and it receives a page from another extension, the
page call becomes an automatically answered intercom call.
PRV
PROGRAMMING OPTIONS
3 .
Use the
GROUP.
LINE GROUP
= L05
: select
SAVE?
4 .
Press SAVE to accept the setting.
LINE GROUP
= L05
Programmed!

SETTING AUTO-MUTE

3 .
Use the
setting.
AUTO-MUTE
= Off
: select
SAVE?
4 .
Press SAVE to accept the setting.
AUTO-MATE
= Off
Programmed!
17
buttons to change the LINE
buttons to change the