Valve Adjusting - O.S. engine FS-30S Owner's Instruction Manual

VALVE ADJUSTING

ALL O.S. four-stroke engines have their valve(tappet)
clearances correctly set before they leave the factory.
However, if, after many hours of running time have
been logged, a loss of power is detected, or if the
engine has to be disassembled or repaired as a result
of an accident, valve clearances should be checked
and readjusted, as necessary an O.S. Valve Adjusting
Tool Kit is available as an optional accessory.
The kit comes in a plastic case and includes:
(Code No.72200060)
• Feeler gauge 0.04mm
• Feeler gauge 0.1mm
• Hex. key 1.5mm
• Wrench 5mm
Note:
If the gap is found to be less than 0.04mm, it is
not necessary to readjust the clearance if the
engine has good compression and starts easily.
Equally, if the gap exceeds 0.10mm but is not
more than 0.14mm (i.e. the thickness of both
feeler gauges inserted together), it is not
necessary to readjust the clearance if the engine
runs satisfactorily.
0.04mm
Feeler Gauge
Rocker Arm
27
(2)
1.
2.
Valve
Fig.1
28
Note:
Valve clearances of all O.S. four-stroke-cycle
engines must be checked and reset ONLY WHEN
THE ENGINE IS COLD.
Procedure is as follows:
(1)
1. Remove the cover from the rocker-box on top of the
cylinderhead, using the correct size Allen hex key.
Turn the propeller counter-clockwise
2.
compression is first felt, then turn it futher quarter
turn. At this point, both valves should be closed. (If
the prop driver ('drive hub') of your engine is
engraved with a letter 'T', this mark should now be
at the top.)
3.
The standard valve clearance, on both inlet and
exhaust valves, is between 0.04mm and
0.10mm(0.0015-0.004 inch), measured between
valve stem and rocker arm. Use the 0.04mm and
0.10mm feeler gauges to check clearances.
(See Fig.1.)
If a clearance is found to be outside either of
these limits, it should be reset as follows.
Carefully loosen the locknut on rocker-arm 1/4-1/2
turn with 5mm wrench. (Fig.2.)
Locknut
Turn adjusting-screw approx. 1/2 turn counter-clockwise
to open gap, using appropriate tool -i.e. Allen hex key.
(Fig.3.)
Adjusting
Screw
until
Loosen approx.
1/4 to 1/2 turn.
Wrench
Fig.2
Turn approx.
1/2 turn.
Allen Key
Fig.3