Decelerating With Cruise Control System; Recovery Of Set Speed - SSANGYONG Korando Owner's Manual

Decelerating with cruise control sys-
tem
• While Cruise control system is running
1. Push down the DECEL.SET. Switch of a
cruise control lever and hold it until the
desired speed is reached without a
brake pedal intervention. But the cruise
control system cannot maintain the
cruise function at less than 34km/h.
2. When the desired speed is reached,
release the lever.
• When Cruise control system is not run-
ning
1. Push down the DECEL.SET. Switch of a
cruise control lever and hold it.
2. And then release the acceleration pedal,
slowly.
3. When the desired speed is reached,
release the lever. But the cruise control
system cannot maintain the cruise func-
tion at less than 34km/h.
• Tap down while cruise control system
is running
1. Push down the DECEL.SET. Switch of a
cruise control lever less than 0.5 sec-
ond per one switching while the cruise
control system is running. This is a tap
down switching.
2. When you operate a tap-down switch-
ing, the vehicle is decelerated for 1km/h
below the previous set speed.
3. If you want to decelerate for 10km/h, op-
erate the tap-down switching ten times
without brake pedal intervention.
INSTRUMENTS AND CONTROLS 3–25

Recovery of set speed

Even if the cruise control is canceled, the
previous set cruise speed can be recovered
by pushing toward the RSM (resume) switch
of a cruise control lever when the current
vehicle speed is higher than 36km/h without
acceleration intervention. But if you turn off
the ignition switch, the memorized set speed
is cleared and you cannot recover the pre-
vious set speed.
CAUTION
The resume position should only be
used if the driver is fully aware of
this speed and wishes to resume this
particular speed.