Setting A Desired Speed; Accelerating With Cruise Control System - SSANGYONG Korando Owner's Manual

3–24 INSTRUMENTS AND CONTROLS

Setting a Desired Speed

1. To operate the cruise control, acceler-
ate to your desired speed using the
acceleration pedal more over 36km/h.
2. When the desired speed is reached,
push up the ACCEL.SET. switch of a
cruise control lever or push down the
DECEL.SET. switch for 1 second per one
switching and then release the accelera-
tion pedal, slowly.
3. Now, the vehicle is cruised by this sys-
tem with set speed.
4. And you can set to other vehicle speed
again with above steps after accelera-
tion pedal intervention during cruise con-
trol running.
Accelerating With Cruise Control Sys-
tem
• While cruise control system is running
1. Push up the ACCEL.SET. switch of a
cruise control lever and hold it until the
desired speed is reached without an
acceleration pedal intervention.
2. When the desired speed is reached,
release the lever.
• While cruise control system is not run-
ning
1. Accelerate using the acceleration pedal
more over 36km/h.
2. Push up the ACCEL.SET switch of a
cruise control lever and hold it.
3. And then release the acceleration pedal,
slowly.
4. When the desired speed is reached,
release the lever.
• Tap up while cruise control system is
running
1. Push up the ACCEL.SET. switch of a
cruise control lever less than 0.5 sec-
ond per one switching while the cruise
control system is running. This is a tap
up switching.
2. When you operate a tap-up switching,
the vehicle is accelerated for 1.3km/h
over the previous set speed.
3. If you want to accelerate for 13km/h, op-
erate the tap-up switching ten times
without accelerating with cruise control
system.