Removing The Spare Wheel; Changing A Wheel - SSANGYONG Korando Owner's Manual

6–4 IN CASE OF EMERGENCY

Removing the Spare Wheel

The spare wheel is located on the tailgate.
1. Remove the key cylinder while inserting
the key into the key cylinder.
2. Unscrew the nut by rotating the wheel
wrench counterclockwise.
3. Remove the spare wheel carefully.

Changing a Wheel

1. Remove the spare wheel from tailgate
with jacking tools.
2. Use the wheel wrench to loosen the
wheel nuts one turn each.
CAUTION
Do not remove any of the nuts until
you have raised that wheel off the
ground.
3. Insert the jack connection rod and the
wheel wrench into the jack.
4. Rotate the jack connection rod clockwise
to raise the lift head slightly.
5. Locate the jack according to the fig.
below.
Jack connection rod
Wheel wrench
6. Place the jack vertically at the front or
rear jacking location closest to the wheel
you plan to change.
CAUTION
Do not attempt to raise vehicle until
the jack is in the proper position,
and secure both to the vehicle and
the ground.
7. Jack up the vehicle by rotating the jack
connection rod clockwise until the tyre
is off ground about 1 inch (3 cm).
(Front)