Makita DUM166 Technical Information page 9

W
iring diagram (cont.)
Fig. D-5
Face its Wire connecting side to Housing L when setting Controller in place.
After setting Controller to Housing L,
the Lead wires have to be put so that
they do not cross over the joint which
accepts Housing R.
Fig. D-6
Do not put AS Lead wire (yellow)
on the top layer of Lead wires
in these Lead wire holders.
Housing set (L)
Terminal
See Figs. D-1 and D-2 for the wiring of Terminal.
Controller
Housing L
Wiring in Housing L
See Fig. D-3 for the wiring of
LED warning lamp.
LED Warning lamp
Switch
DC motor
Lead wire holder
Wire connecting side
Neither AS Lead wire (yellow) nor
Warning lamp's Lead wires (black, red)
should be the top layer of all Lead wires
in this Lead wire holder.
See Fig. D-5 for
the wiring of
Controller.
See Fig. D-4 for the wiring of DC motor.
P 9/ 9
joint
Controller