Table of Contents
Advertisement
NOTE:
If you are unsure how to connect your oven, please consult an authorised, qualifi ed electrician.
Neither the manufacturer nor the dealer can accept any liability for damage to the oven or personal injury
resulting from failure to observe the correct electrical connection procedure.
Water vapour or drops may occasionally form on the oven walls or around the door seals and sealing surfaces.
This is a normal occurrence and is not an indication of microwave leakage or a malfunction.
1. Remove all packing materials from the inside of
the oven cavity and remove any protective film
found on the microwave oven cabinet surface.
2. Check the oven carefully for any signs of damage.
3. Place the oven on a secure, level surface, strong
enough to take the oven weight, plus the heaviest
item likely to be cooked in the oven. Do not place
the oven in a cabinet.
4. Select a level surface that provides enough open
space for the intake and/or outlet vents.
The rear surface of appliance shall be placed
against a wall.
• The minimum installation height is 85 cm.
• A minimum space of 20 cm is required between
the oven and any adjacent walls.
• Leave a minimum space of 30 cm above the oven.
• Do not remove the feet from the bottom of the
oven.
• Blocking the intake and/or outlet openings can
damage the oven.
• Place the oven as far away from radios and TV
as possible. Operation of microwave oven may
cause interference to your radio or TV reception.
30 cm
20 cm
20 cm
min
85 cm
5. Securely connect the plug of the oven to a standard
earthed (grounded) household electrical outlet.
WARNING: THIS APPLIANCE MUST BE EARTHED
To wire an appropriate plug, follow the wiring code given in o replace the mains plug' on page 17.
Plug in the oven. The oven display will display: "0:00", an audible signal will sound once.
This model has a clock function and the oven uses less than 1.0W in stand by mode.
To set the clock, see next page.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Do not place the oven where heat,
moisture or high humidity are generated, (for
example, near or above a conventional oven) or near
combustible materials (for example, curtains).
Do not block or obstruct air vent openings.
Do not place objects on top of the oven.
This symbol means that the surfaces are liable to get
hot during use.
BUILDING-IN-KIT
No built-in kit is available for this oven.
This oven is designed to be used on a countertop
only.
ELECTRICAL CONNECTION
• Do not allow water to come into contact with the
power supply cord or plug.
• Insert the plug properly into the socket.
• Do not connect other appliances to the same
socket using an adaptor plug.
• If the power supply cord is damaged, it must be
replaced by a Sharp approved service facility or a
similarly qualifi ed person to avoid a hazard.
• When removing the plug from the socket always
grip the plug, never the cord as this may damage
the power supply cord and the connections inside
the plug.
• If the plug fi tted to your oven is a rewireable type
and in the event of the socket outlet in your home
not being compatible with the plug supplied,
remove the plug properly (do not cut off ).
• If the plug fitted to your oven is a non-rewirable
type and in the event of the socket outlet in your
home not being compatible with the plug supplied,
cut-off the mains plug.
• Refi t with a suitable type, observing the wiring code
given in 'To replace the mains plug' on page 17.
GB-7
INSTALLATION
t
BEFORE OPERATION
Hide quick links:
Advertisement
Table of Contents
