Fcc Statement - Hilti PR 25 Operating Instructions Manual

12. FCC statement (applicable in US) / IC statement (applicable in Canada)
-CAUTION-
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
en
part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio com-
munications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment on and off, the user is encour-
aged to try to correct the interference by one or more of
the following measures:
Re-orient or re-locate the receiving antenna.
Increase the distance between the equipment and
receiver.
Connect the equipment to an outlet on a circuit dif-
ferent from that to which the receiver is connected.
Consult the dealer or an experienced TV/radio tech-
nician for assistance.
Changes or modifications not expressly approved by
Hilti could restrict the user's right to operate the equip-
ment.
12
This device complies with Part 15 of the FCC Rules and
RSS-210 of IC. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Information plates on the product:
Made in Germany
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
LASER RADIATION - DO NOT
STARE INTO BEAM
This Laser Product
EN 60825-1:2003
620-690nm/0.95mW max.
complies with 21CFR
1040 as applicable
CLASS II LASER PRODUCT
Power: 4,5V=nom./150 mA
Made in Germany
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
LASER RADIATION - DO NOT STARE INTO
BEAM OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS
620-690nm/2.45mW max.
CLASS IIIa LASER PRODUCT
PR 25
1/4 s
2
PR 25 IF
3A
This Laser Product
EN 60825-1:2003
complies with 21CFR
1040 as applicable
Power: 4,5V=nom./150 mA