Canon WUX6010 User Manual page 195

Cause
The lamp has ruptured
(or there is a lamp
malfunction).
The operating
environment is
inappropriate.
■ The Projector Cannot Join the Network
Cause
The LAN cable (shielded
twisted pair) is not
connected correctly.
[HDBaseT] was changed
from [On] to [Off] while
[Communication
settings] > [Wired
network] was set to
[HDBaseT].
The projector has not
been on long enough
(less than about 40
seconds).
Countermeasure
If the lamp has ruptured, follow the instructions in
"Precautions when replacing lamps that stop
working" (P15).
Check whether the operating temperature is between
0°C (32°F) and 40°C (104°F). (P19)
Projector settings must be adjusted when using the
projector at altitudes of 2,300 m (7,545.8') or higher.
In the [Install settings] menu, set [Fan mode] under
[Professional settings] to [High altitude]. (P99)
Countermeasure
Check whether the LAN cable (shielded twisted pair)
is connected to the projector correctly. (P120)
Configure the [HDBaseT] setting again as follows.
(P111)
1. Change the [HDBaseT] setting from [Off] to [On]
again.
2. Change the wired network setting from [LAN port]
to [HDBaseT].
3. Following the instructions shown, press the
POWER button to enter standby mode
temporarily.
4. After at least five minutes, press the POWER
button again.
Network connections are not available until about 40
seconds after startup. Wait at least 40 seconds, and
then try to connect again. (P131)
195
Troubleshooting