Sagitter HYP006WW User Manual page 7

Connection of DMX Signal Wire
1
Please use the fixture controller wire specially when use the DMX512
Controller. Connect the (male) 3 pin connector side of the DMX cable to
the output (female) 3 pin connector of the first fixture.
2
Connect the end of the cable coming from the first fixture which will have
a (male) 3 pin connector to the input connector of the next fixture
consisting of a (female) 3 pin connector. Then, proceed to connect from
the output as stated above to the input of the following fixture and so on.
3
This product can be connected numerous lamps in series without the
need for the signal amplifier; the signal will not be weakened.
3-PIN TO 5-PIN CONVERSION CHART
Note! If you use a controller with a 5 pin DMX output connector, you will
need to use a 5 pin to 3 pin adapter.
3 PIN TO 5 PIN CONVERSION CHART
Conductor
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
DMX IN
3 Pin Female(output)
Pin 1
Pin2
Pin 3
DMXOUT DMX IN DMXOUT
5 Pin Male (Input)
Pin 1
Pin2
Pin 3
Do not use
Do not use
7
DMX IN DMXOUT