Desktop Chargers; Rapid Charger - Motorola CP200 User Manual

DESKTOP CHARGERS

Rapid Charger

1 Turn the radio off.
2 Place the battery, with or without the radio, in
the charger pocket.
•
LED color
No LED Indication
Single Green Flash
Flashing Red
Steady Red
Flashing Yellow
18
English
The charger LED indicates the charging
progress.
Status
Battery inserted incorrectly
or battery not detected.
Successful charger
power-up.
*
Battery unchargeable or not
making proper contact.
Battery is in Rapid charge
mode.
Battery in charger but wait-
ing to be charged. The bat-
tery temperature may be too
hot or too cold. The voltage
may be lower than the pre-
determined threshold level
for charging.
LED color
†
Flashing Green Battery 90% (or more)
charged. Trickle charging.
Green Battery fully charged.
* Remove the battery from the charger and
use a pencil eraser to clean the three metal
contacts at the back of the battery. Place the
battery back into the charger. If the LED
indicator continues to flash red, replace the
battery.
† A standard battery may require 90 minutes to
charge to 90% capacity. Even though new
batteries might prematurely indicate a full
charge (steady green LED), charge the
battery for 14 to 16 hours prior to initial use
for best performance.
A list of Motorola authorized batteries and
battery chargers appears on page 35. The
listed chargers will charge only Motorola
authorized batteries. Other batteries may not
charge.
Status