Problems; Trouble Shooting; Check List - Ecomiser SU-01 Manual

If you should experience a problem with your dishwasher, you should review the following list of
frequently encountered situations. Even though the product is under warranty, if the problem is not
caused by defective product workmanship or materials, you will be charged for a service call. If you're
still not sure, contact Ecomiser regional agent before you call a service technician.
NORMAL PROBLEMS
- Always, fresh detergent should be used.
- The amount of detergent needed for dishware depends on the hardness of the water in your area.
Contact your local utility company to learn the water hardness in your area.
- Make sure the machine is level.
- Dishwasher runs too long. If the temperature of the water entering the machine is below 59℉/15℃
(SU02) and 140℉/60℃ (SU01), the machine runs longer because it heats the water to the proper
temperature by the memorized program.
DRAIN
- Make sure that the cycle is complete before you open the dishwasher. If not, allow it to complete and check again.
- Check the drain area for blockage.
- Check for a kink in the drain hose.
WATER FILL
- Make sure the water supply is turned on.
- Make sure the dishwasher is turned on and the door is closed securely.
- Check for crimps in the water feed line.
- Make sure the water inlet valve is not clogged.
DOESN'T START
- Make sure the dishwasher is turned on and the door is closed securely.
- Check that the water supply is connected properly and the water is turned on.
- Make sure the power cord is properly connected into the power supply box.
- Check your fuse box for a blown fuse or tripped circuit breaker.
Nonconformity
Is the power not Is the breaker on?
coming on? Did you press the power button?
No water supply? Is the water supply valve open?
Is the machine level to the ground?
Makes a lot of
Is the spray arm touching the plates?
noise?
Are chemical containers empty?
Is the drain hose bent?
No drain? Is the drain higher than the water level?
Is the impellers clogged?
Impellers not rotate?
Is the dishware close together?
Poor washing?
Are you out of detergent?
Are dried food bits stuck to the
dishware?
Are there stains on the dishware?
Poor rinsing? Is the dishware slippery?
Poor drying performance?
Did you use the proper detergent?
Too much
The wash temperature too low?
foaming?

Check List

Check
Ecomiser SU-01 / SU-02 Manual 18/21 Page Rev.05
Corrective Action
Turn the breaker on
Press the power button
Turn the water supply valve open
Install the machine parallel to the ground
Don't let the nozzle touch the machine
Fill detergent and rinse into empty containers
Make sure the hose isn't bent
Make sure the drain is installed at the bottom
level
Clean up impeller nozzles
Do not load dishware too high
Do not load dishware too close
Refill the detergent
Rinse off the dried food bits before putting
into the machine
Check the temperature
Check the amount of rinse detergent
Check the temperature
Use the proper detergent fir for the machine
After confirming the water supply line, check
the temperature