Ecomiser SU-01 Manual page 13

CONTROL SYSTEM
A) The left display
- Temperature inside wash tank
- Set mode (when pushing the mode key)
B) The right display
- Temperature inside rinse tank
- Setting data (time, temperature)
- Error code
C) LED
- Ready: The light is on when wash mode is ready to be started with the temperature 180℉ (82℃)
inside rinse tank after the first run. The first run will be started after satisfying programed
temperature (washing tank 140℉/60℃, rising tank 203℉/95℃). It takes about one hour depending
on incoming water temperature.
- Water: The light is on when supplying water.
- Heater: The light is on when the heater is operating.
- Operating state: Each light is on when indicating the present working (washing, detergent supply,
waiting, rinsing, rinse supply, completion of work)
- Temperature unit (C: ℃, F:℉)
D) Key
Use these buttons when you want to operate the machine.
- POWER
1) Power On/Off
2) All activation will be stopped when power off.
3) When canceling error messages.
- START/STOP
1) When starting or stopping the washing operation.
2) In state of [PAU], if you try to push any key, the keys operation will not function.
- MODE KEY
1) When push holding the key 1 time, it is possible to change the washing time after about 6
seconds.
2) Push again 1 time after window changes  detergent incoming time (Minimum. 3 seconds)
3) 2 times  waiting time
4) 3 times  rinsing time
4 times  rinse incoming time (Minimum. 3 seconds)
5)
5 times  heater control temperature (high)
6)
6 times  heater control temperature (low)
7)
7 times  buzzer on or off
8)
9) 8 times  temperature unit (℃, ℉)
10) 9 times  drain time
10 times  model type (door, under)
11)
11 times  completing (early mode)
12)
Ecomiser SU-01 / SU-02 Manual 13/21 Page Rev.05