Care & Cleaning - Ecomiser SU-01 Manual

- UP/DOWN
1) Possible to change the amount of time and temperature on each mode through the right display.
2) Continually pushing the key, the value of time and temperature will continue bigger or smaller
incrementally.
- WATER
1) Water fill is continuous before all of float switches equipped on the washing and rising tank
reach "ON" state.
2) When the tank float switch is off, incoming water stops.
- TEMPERATURE AT THE WAITING MODE
1) The left display shows the temperature inside washing tank and the right display shows it
inside rinsing tank.
2) As long as the temperature is not going up to 180℉ (82℃), the Ready LED lamp is OFF and the
machine does not work. But the temperature reaches to 180℉ (82℃), the Ready LED lamp is
ON and the machine works.
- WASHING MODE
1) When the door will be closed from the open state, washing cycle starts in 2 seconds.
2) When the door will be closed, if you push the START/STOP key, the machine will work again.
3) It begins to supply detergent by using a specialized pump.
- WAITING MODE
After coming to an end of the wash mode, the machine goes into a waiting mode for draining waste
water for the preset cycle.
- RINSING MODE
1) After waiting mode the rinse pump starts to work and the rinsing process begins.
2) It begins to supply rinse by using a specialized pump and comes to an end of the rinsing
process along the preset time.
- END MODE
1) All steps for doing dishes are completed along given options then the FINISH LED lamp will be
flashing.
2) When the finish LED displays the buzzer will sound 3 times.
- ERROR MASSAGE
An error will display in the LED window if a fault occurs while a program is in progress. The table
below defines each error message.
1) Whenever an error happens, all functions stop automatically and the buzzer sounds 5 times. In
this mode call a service agent.
2) To cancel the error, push the POWER key.
a) [E1]  washing temperature sensor is open/short or temperature is over 230℉ (110℃).
b) [E2]  temperature sensor (upper rinsing tank) is open/short or temperature is over 230℉
(110℃).
c) [E3]  temperature sensor (lower rinsing tank) is open/short or temperature is over 230℉
(110℃) in use of Eco-Type.
d) [EF1]  no new water has been supplied to the machine for 15 minutes.
e) [EF2]  under the condition of rinsing tank full, no water has been supplied to the washing
tank for 40 minutes.
f) [ED1]  when upper one of two ball water level sensor is on, all functions of the machine
will be stopped.
Ecomiser SU-01 / SU-02 Manual 14/21 Page Rev.05