Table of Contents
Advertisement
Using the Configuration Menu
Home > Wireless > 802.11g
Wireless Settings-
choose 802.11a or 802.11g. Here, 802.11g is selected.
SSID-
"default" is the default setting. All devices on the network must
share the same SSID. The SSID may be up to 32 characters
long.
Channel-
1 is the default channel for 802.11g. All devices on the network
must share the same channel.
WEP-
select Enabled or Disabled. Disabled is the default setting.
WEP Encryption-
select the level of encryption desired: 64, 128 or 152-bit
WEP (Wired Equivalent Privacy) If you enable encryption on the DI-774
make sure to also enable encryption on all 802.11g wireless clients or
wireless connection will not be established.
select HEX or ASCII
Key Type-
Keys 1-4-
input up to 4 WEP keys; select the one you wish to use.
14
Using the Configuration Menu
Home > WAN > Dynamic IP Address
Dynamic
most Cable modem users will select this option to obtain an IP
IP Address-
Address automatically from their ISP (Internet Service Pro-
vider).
Host Name-
this is optional, but may be required by some ISPs. The host
name is the device name of the Router.
MAC Address-
the default MAC Address is set to the WAN's physical interface
MAC address on the Router.
Clone
copy the MAC address of the Ethernet card installed by your
MAC Address-
ISP, and replace the WAN MAC address with this Ethernet card
MAC address. It is not recommended that you change the de-
fault MAC address unless required by your ISP.
enter a DNS Address if you do not wish to use the one provided
Primary/Secondary
by your ISP.
DNS-
enter an MTU value only if required by your ISP. Otherwise,
MTU-
leave this section to its default setting of 1500.
15
Advertisement
Table of Contents
