eLine ELI-SIP2-NVR16 User Manual page 54

Please follow the procedures below to go on cable connection
Connect the dome RS485 port to NVR RS485 port.

Connect dome video output cable to NVR video input port.

Connect power adapter to the dome.

In the main menu, from Setting->System->PTZ, you can see an interface is shown as in Figure 4-36.
Here you can set the following items:
Channel: Select the current camera channel.

PTZ type: There are two types: local/remote. Please select local mode if you are connect RS485

cable to connect to the Speed dome (PTZ). Please select remote mode if you are connecting to the
network PTZ camera.
Protocol: Select corresponding PTZ protocol(such as PELCOD)

Address: Default address is 1.

Baud rate: Select corresponding baud rate. Default value is 9600.

Data bit: Select corresponding data bits. Default value is 8.

Stop bit: Select corresponding stop bits. Default value is 1.

Parity: There are three options: odd/even/none. Default setup is none.

If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 4-37.
Figure 4-36
137