Table of Contents
Advertisement
Please refer to the following sheet for detailed information.
Parameter Function
Channel
PTZ Type
Protocol
Address
Baud
Rate
Data Bit
Stop bit
Figure 5-103
Figure 5-104
Select speed dome connected channel.
There are two options: local/remote.
Please select remote type if you are connecting to the network PTZ.
Select the corresponding dome protocol such as PELCOD.
Set corresponding dome address. Default value is 1. Please note
your setup here shall comply with your dome address; otherwise
you can not control the speed dome.
Select the dome baud rate. Default setup is 1115200.
The value ranges from 5 to 8. Default setup is 8. Please set according
to the speed dome dial switch setup.
The value ranges from 1 to 2. Default setup is 1. Please set according
298
Advertisement
Table of Contents
