Image - eLine ELI-SIP2-NVR16 User Manual

Parameter
Modify
Delete
Connection
status
Delete
Manual
Add

5.8.1.2 Image

Note
Slight difference may be found since the connected network camera may not be same model.
Here you can view device property information. The setups become valid immediately after you set. See
Figure 5-20.
Function
Click or any device in the Added device list, you can change the
corresponding channel setup.
Click , you can delete the remote connection of the corresponding
channel.
: Connection succeeded.
: Connection failed.
Select a device in the Added device list and then click Delete button,
system can disconnect the device and remove it from the Added
device list.
Click it, the interface is shown as in Figure 5-19. Here you can add
network camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.)
Note:
System supports manufactures such as Panasonic, Sony,

Dynacolor, Samsung, AXIS, Arecont, and Onvif standard
protocol.
If you do not input IP address here. System uses default IP

192.168.0.0 and system does not connect to this IP.
Can not add two devices at the same time. Click OK button here,

system only connect to the corresponding device of current
channel.
245