Weekly Cleaning Of The Machine; Brew Group Cleaning; Weekly Brew Group Cleaning Cycle - Saeco HD8914 Instruction Manual

7.1.2

Weekly cleaning of the machine

7.2

Brew group cleaning

7.2.1

Weekly brew group cleaning cycle

12
ENGLISH
Incanto_AMF_EN-IT-DE_Rev01.indb 12
Follow the step-by-step instructions in the "7.1.1 Machine cleaning when needed"
>
chapter until you reach the seat of the drip tray. Now clean the drip tray seat.
>
Place the components back.
The brew group must be cleaned at least once a week.
Weekly cleaning of the brew group is a cleaning cycle with water (accurate rinsing).
Disassembly and cleaning phase
> Turn the machine off with the STAND-BY button. Wait for the STAND-BY button to
start flashing and disconnect the power cord plug.
>
Press the side buttons.
>
Remove the drip tray.
>
Open the service door.
>
To remove the brew group:
• Place the thumb on the PUSH button and then the other fingers, on the handle.
• Press the PUSH button and pull the handle.
>
Remove horizontally without rotating it.
>
Clean the coffee outlet duct thoroughly with the appropriate cleaning tool, supplied
together with the machine.
>
Remove the coffee residues drawer and wash it thoroughly.
Wash the brew group accurately with lukewarm water and clean the upper filter
>
accurately.
Do not use detergents or soap to clean the brew group.
>
Let the brew group air dry completely.
>
Clean the inside of the machine accurately with a wet soft cloth.
Reassembly phase
> Insert the coffee residues drawer in its seat and check that it is placed correctly.
If the coffee residues drawer is not placed correctly, it might be impossible to place
the brew group in the machine.
>
Make sure that the brew group is in the idle position: the two reference marks on the
side of the brew group must match.
> If they do not match, press the lever slightly downwards until it touches the base of
the brew group, so that the two check reference marks match.
27/03/15 09:58