Power Elevating Seat Option; Transit Securement System - Quantum edge 2.0 Owner's Manual

MANDATORY! Prevent controller harness damage! Avoid routing
the controller harness on the outside of the armrest pad. Route the
harness under the armrest or toward the inside of the armrest pad. Use
correct tie-down points for controller harness to prevent the harness
from getting caught in the drive tires, pinched in the seat frame, or
damaged when passing through doorways.
5. Plug the controller connector into the rear of the power base. See
fi gure 1.
6. Secure the controller harness to the armrest receiver with wire ties. See
fi gure 8.

Power Elevating Seat Option

Your power chair may be equipped with a power elevating seat option.
While the seat itself may be any one of the styles offered for this model, the
way the seat base attaches to the power base is different.
To install the power elevating seat:
1. Place the seat plate interface bracket onto the actuator. See fi gure 9.
2. Insert the supplied hardware into the actuator and tighten the hardware.
3. Place the seating system onto the seat plate and secure.
4. Plug in the power seat toggle switch harness, if equipped.

Transit Securement System

If your power chair is equipped with a transit securement system, it is
equipped with manufacturer-installed front and rear securement brackets
and may be equipped with positioning belt anchoring brackets. See fi g-
ure 10. Refer to the supplement provided with your power chair for informa-
tion on how to use the transit securement system.
