Comfort Adjustments; Seat Height And Seat Angle Adjustment - Quantum edge 2.0 Owner's Manual



Comfort Adjustments

After becoming familiar with your power chair's operation, you may fi nd the
need to make some adjustments to increase your comfort, such as seat
height and angle, armrest width, angle and height, foot platform height,
depth, and angle, and controller position.
NOTE: If your power chair is equipped with a Synergy Seat or TRU-
Balance® Power Positioning System, refer to the seat adjustment
information contained in separate manuals. If your power chair is
equipped with a contoured seating system, refer to the following
information.
WARNING! The center of gravity of your power chair was factory set to
a position that meets the needs of the demographic majority of users.
Your Quantum Rehab Provider has evaluated your power chair and
made any necessary adjustments to suit your specifi c requirements.
Do not change your seating confi guration without fi rst contacting
Quantum Rehab or your Quantum Rehab Provider.
WARNING! Some power chair components are heavy. You may need
assistance to lift or carry them. Please refer to the specifi cations table
for specifi c component weights before you disassemble the power
chair.
WARNING! Remove the occupant from the power chair before making
any adjustments.
You may need the following to make comfort adjustments:
 metric/standard socket set and ratchet
 adjustable wrench
 metric/standard hex key set
 thread lock

Seat Height and Seat Angle Adjustment

If your power chair is not equipped with a transit securement system, you
can change the seat height to one of three positions by raising the front and
rear trapeze bars. If you raise or lower only one trapeze bar (front or rear),
you can also change the seat base angle (dump).
MANDATORY! If your power chair is equipped with a transit securement
system and any adjustment to the seat height or seat angle is necessary,
contact your Quantum Rehab Provider. These comfort adjustment can
only be made by a Quantum Rehab Provider.
To change the seat height:
1. Turn off the power to the controller.
2. Make sure the power chair is in drive mode.
3. Unplug the controller connector(s) from the power base. See fi gure 1.
Comfort Adjustments