Saving Power In Standby Mode; Enabling The Ir Repeater Function (When You Cannot Control The Tv); Further Settings For The Wireless System - Sony HT-NT3 Operating Instructions Manual

Saving power in Standby
Mode
Check that you have made the following
settings:
 [Bluetooth Standby] is set to [Off]
(page 24).
 [Control for HDMI] in [HDMI Settings] is
set to [Off] (page 26).
 [Quick Start Mode] is set to [Off]
(page 26).
 [Remote Start] is set to [Off] (page 28).
Enabling the IR repeater
function (when you
cannot control the TV)
When the Bar Speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the remote
control of the TV by sending the remote
signal from the rear of the Bar Speaker.
Note

Be sure to check that the remote control
of the TV cannot control the TV, then set
[IR-Repeater] to [On]. If it is set to [On]
when the remote control can control the
TV, appropriate operation may not be
obtained, because of the interference
between the direct command from the
remote control and the command via the
Bar Speaker.

On some TVs, this function may not work
correctly. In this case, place the Bar
Speaker slightly further away from the TV.
1
Press HOME on the remote control
of the system.
The home screen appears on the TV
screen.
2
Press  to select
upper right corner, then press
3
Press / to select [System
Settings], then press
4
Press / to select [IR-Repeater],
then press .
5
Press / to select [On], then
press .
Further settings for the
wireless system
You can make further settings for the
wireless system by using the [Wireless
Sound Connection] settings.
1
Press HOME.
The home screen appears on the TV
screen.
2
Press  to select
upper right corner, then press
3
Press / to select [System
Settings], then press
[Setup] at the
.
.
[Setup] at the
.
.
33
GB