Changing The Brightness; Saving Power In Standby Mode; Enabling The Ir Repeater Function (When You Cannot Control The Tv) - Sony HT-ST9 User Manual

Changing the brightness

You can change the brightness of the front panel display and blue
LED indicator.
Press DIMMER repeatedly.
You can adjust the brightness in 3 levels.*
* The brightness for "DIM1" and "DIM2" settings are the same.
Note
The front panel display is turned off when "DIM2" is selected. It turns on
automatically when you press any buttons, then turns off again if you do
not operate the system for about 10 seconds. However, in some cases,
the front panel display may not turn off.

Saving Power in Standby Mode

Check that you have made the following settings:
– [Bluetooth Standby] is set to [Off] (page 25).
– [Standby Through] is set to [Off] (page 26).
– [Quick Start/Network Standby] is set to [Off] (page 26).
– [Remote Start] is set to [Off] (page 27).
34
GB
Enabling the IR Repeater Function (when
you cannot control the TV)
When the Bar Speaker obstructs the remote control sensor of the TV,
the TV remote control may not work. In that case, enable the IR
repeater function of the system.
You can control the TV with the remote control of the TV by sending
the remote signal from the rear of the Bar Speaker.
Note
Be sure to check that the remote control of the TV cannot control the TV,
and then set [IR-Repeater] to [On] (page 25). If it is set to [On] when the
remote control can control the TV, appropriate operation may not be
obtained because of the interference between the direct command from
the remote control and the command via the system.